LineGrabber™ Specifications
LG-2MSJ
|
LG-2WP
|
|
Security Features: |
||
| Full line Seizure | Yes | Yes |
| Off-Hook, Dry Line Recovery | Yes | Yes |
| Fail Safe Operation | Yes | Yes |
| Transient Protection | Yes | Yes |
| Non-Polarized * | Yes | Yes |
| Loop Powered | Yes | Yes |
General Features: |
||
| Security System, Priority Level 1 The Alarm Control May Be Connected Anywhere on the Phone Line. The LineGrabber™ is NOT used with the Alarm Control |
In Alarm Condition
All LineGrabber™ Equipped Phone Devices Are Disconnected. All Phone Devices That Share the Phone Line With the Alarm Control MUST Be LineGrabber™ Equipped |
In Alarm Condition
All LineGrabber ™ Equipped Phone Devices Are Disconnected. All Phone Devices That Share the Phone Line With the Alarm Control MUST Be LineGrabber™ Equipped |
| Voice Equipment Priority Level 2 |
In Normal Use the LineGrabber™ System is transparent to the end user |
In Normal Use the LineGrabber™ System is transparent to the end user |
| Modem Compatible | Yes, Dialup and DSL | Yes, Dialup and DSL |
| Telephone Device
Compatibility |
Tone & Pulse
Dial “POTS” (plain old telephone service) |
Tone & Pulse
Dial "POTS" (plain old telephone service) |
| Network Compatibility | Single-line Analog, loop start, W/Caller ID, Studder Tone, DSL Filter Installation, Calling/Called Party Control and DSL Splitter-less Installation | Single-line Analog, loop start, W/Caller ID, Studder Tone, DSL Filter Installation, Calling/Called Party Control and DSL Splitter-less Installation |
| Interconnection | RJ11 Jack, Tel Line
Connection RJ11 Jack, Phone Device Connection |
Direct Tel Line, Wire Terminals Connection RJ11 Jack, in front for Phone Device Connection, RJ11 Jack, In Rear of Housing For Alarm Control |
| Package High impact plastic UL 94V-0 |
Plastic In Line Module, Can Be Wall Mounted 2.3” x 1.3” x 0.9” | Plastic Wall Plate, For Use With Wall Phones. Can also Be Used To Replace Standard Wall Jacks For Permanent LineGrabber™ Installation |
| Consumer Installation | Yes, 1 Per Phone Device Required |
Yes, 1 Per Phone Device Required |
| Certifications | FCC CFR47 PART 68 UL 985-1023-1637 |
FCC CFR47 PART 68 UL 985-1023-1637 |
| Manufacture | US and China | US and China |
| US Patent | 5,799,062 | 5,799,062 |
Specifications Subject To Change Without
Notice
* If the phone device does not work after installing the
LineGrabber™ it may be that the Tip & Ring wires are reversed, on the LG-2MSJ reverse the wall and phone RJ11 plugs, on the LG-2WP
reverse the tip and ring wires, then take the receiver off-hook
and dial a number to verify operation.
Line Grabber, Line seizure